Novine vezane za najjnoviju verziju programa JARRAC
(Jarrac2000)

* Ceo kod programa prebacen u C++ programski jezik radi kompaktnosti i brzine izvrsavanja programa.

* Mogucnost pojedinacnog podesavanja teksture elemenata

* Ubacena mogucnost racunanja i obelezavanja kantiranja u semi rezanja

* Ubaceno izracunavanje cenovnika usluga (cena materijala, kantiranje, po duzini rezanja, broj izrezanih tabli i sl..)

* Postoje samo dva algoritma AUTOMATSKI (novi automatski algoritam koji zamenjuje sve predhodne verzije aut.algoritme i objedinjuje ih u jedan) i MANUELNI.

* Mogucnost oduzimanja iskoriscenih tabli (iz tabele tabli) posle rezanja

* Mogucnost korekcije zadnje table iz automatskog algoritma sa manuelnim algoritmom.

* Spajanje viskova bez "Osvezavanja"

* Prebacivanje "dobrih viskova" posle secenja iz seme krojenja ponovo u tabelu tabli (na ponovno secenje, koriscenje dobrih viskova)

News concerning the newest version of JARRAC Optimizer
(Jarrac2000)

* The code has been converted to C++ program format for for faster application processing.

* Capability for item grain direction.

* Edging summary listing total linear measure of tape of edge required.

* Automatic calculation of cutting lists from finished sizes, including edge-banding length and material costs.

* Two new special algorithms, faster - AUTOMATIC and slower - MANUAL  but with better optimization capabilities.

* Capability for subtraction of used panels/sheets after optimization.

* Capability of correction of the end optimized panel/sheet into the MANUAL algorithm mode.

* Welding left-overs without "Refresh".

*  Transfer of "acceptable left-overs" from the optimization solution into the data table for new optimization.